Wubster100 Posted Monday at 04:18 PM Report Share Posted Monday at 04:18 PM (edited) 1 hour ago, Iroga said: Maybe the problem is with the camera itself? Should I try replacing it? Or will it not help? Before you replace the camera itself, you must verify the integrity of the wiring, connectors, and terminals. No short circuits, open circuits, poor connections, etc. Edited Monday at 04:18 PM by Wubster100 Quote Link to comment Share on other sites More sharing options...
Wubster100 Posted Monday at 04:19 PM Report Share Posted Monday at 04:19 PM Have you made any AsBuilt modifications that may have caused this? Quote Link to comment Share on other sites More sharing options...
Iroga Posted Monday at 07:02 PM Author Report Share Posted Monday at 07:02 PM I will follow your recommendations. I have not made any changes. 1 Quote Link to comment Share on other sites More sharing options...
Iroga Posted Tuesday at 12:30 PM Author Report Share Posted Tuesday at 12:30 PM Did as recommended. Disconnected the connector. Rebooted the IMPA module. Enabled self-test. The result is in the photo. 1 Quote Link to comment Share on other sites More sharing options...
Wubster100 Posted Wednesday at 04:26 PM Report Share Posted Wednesday at 04:26 PM There is definitely an issue with the IPMA or the wiring. Clearly the IPMA thinks that the heater circuit does not have any problems, but that is not true because the heater was disconnected from the IPMA. Quote Link to comment Share on other sites More sharing options...
Iroga Posted Thursday at 02:13 PM Author Report Share Posted Thursday at 02:13 PM (edited) 22 hours ago, Wubster100 said: There is definitely an issue with the IPMA or the wiring. Clearly the IPMA thinks that the heater circuit does not have any problems, but that is not true because the heater was disconnected from the IPMA. It's already warm and I won't be able to check the operation. I'll try to connect another camera later. I'll check the wiring from the camera, of course. If you disconnect the rain sensor, then Forscan sees that it's not there. Can updating the camera firmware help? Edited Thursday at 02:29 PM by Iroga Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.