BMWR1200c Posted October 31 Report Share Posted October 31 When a 2020 SEL windshield with the rain sensors is replaced, does the rain sensor need to be calibrated or recalibrated, or is it simply replace, plug and play? And are the rain sensors integrated in the glass, or just replace the windshield and re-use the old sensors? Thanks! Quote Link to comment Share on other sites More sharing options...
1004ron Posted November 1 Report Share Posted November 1 Not the rain sensor, only the lane assist camera needs calibration. Find an installer that will install an OEM windshield with the same spec that you see on the existing one. I'd advise against SafeLite - I had a bad experience with them installing windshields with defects that had a poor repair attempted - took three tries, and even then the clips for the plastic trim were not correctly installed. 1 Quote Link to comment Share on other sites More sharing options...
Haz Posted November 1 Report Share Posted November 1 @BMWR1200c: For your technical awareness, attached below as PDF documents... Good luck! Rain Sensor - Removal and Installation - 2020 Edge Workshop Manual.pdf Image Processing Module A (IPMA) - Removal and Installation - 2020 Edge Workshop Manual.pdf 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.