ProjectPat Posted September 22 Report Share Posted September 22 My cable for my shifter came disconnected from the lever of the transmission. I bought a new bushing and everything seemed fine, then it slipped again. So I looked further into it, and it seems like the nipple on the lever that attaches to the transmission might be the problem but I am having trouble finding a replacement lever. Any help would be much appreciated Quote Link to comment Share on other sites More sharing options...
1004ron Posted September 22 Report Share Posted September 22 Welcome. Could you post a photo so that we can have better idea of which part you're referring to. Quote Link to comment Share on other sites More sharing options...
Haz Posted September 23 Report Share Posted September 23 Welcome to the Forum @ProjectPat! Are you certain the cable-end locking clip is fully engaged after you mount the shifter cable onto the ball stud of the manual shifter lever, as depicted below?... Carefully pry outward the adjuster lock tabs. While holding the adjuster lock tabs outward, slide the lock to unlock the selector lever cable... NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the selector lever cable bracket. NOTE: Make sure that the selector lever cable end is correctly installed onto the manual control lever ball stud by pulling back on the selector lever cable end... NOTE: After locking the adjuster, pull back on the adjuster to make sure it is securely installed... This 2013 Edge Workshop Manual procedure is also attached below as a PDF document... Good luck! Selector Lever Cable Adjustment — 6F35 - General Procedures - 2013 Edge Workshop Manual.pdf 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.