Vanquished Posted July 23, 2022 Report Share Posted July 23, 2022 (edited) Hey folks. Just thought I'd give you a heads up. Dongar Technologies finally made a 5-PIN adapter for our Ford Edges. This allows you to quickly and easily run a dashcam off your rearview mirror power without having to use a wiretap. I just did a full Install video of it here: Hope it helps! Edited July 23, 2022 by Vanquished 6 2 Quote Link to comment Share on other sites More sharing options...
ben senise Posted July 24, 2022 Report Share Posted July 24, 2022 that's great info. thanks for making the video. 1 Quote Link to comment Share on other sites More sharing options...
Vanquished Posted July 25, 2022 Author Report Share Posted July 25, 2022 On 7/24/2022 at 10:38 AM, ben senise said: that's great info. thanks for making the video. Np. I had another video with a wiretap but it was hard to see. I actually propped the camera up this time so I think it came out a lot better haha. Took probably 10 minutes to do it all. 1 Quote Link to comment Share on other sites More sharing options...
txaggie Posted July 26, 2022 Report Share Posted July 26, 2022 Thanks for posting!! 1 Quote Link to comment Share on other sites More sharing options...
awmustang Posted August 7, 2022 Report Share Posted August 7, 2022 (edited) What year is your Edge? We have a 2019 and I'm hoping this will work for it. The Dongar site says 21+. And this powers down as soon as the car is off and door is opened right? (That's my issue with using the 12 volt sockets, they stayed powered for too long). Edited August 7, 2022 by awmustang clarification Quote Link to comment Share on other sites More sharing options...
Vanquished Posted August 8, 2022 Author Report Share Posted August 8, 2022 17 hours ago, awmustang said: What year is your Edge? We have a 2019 and I'm hoping this will work for it. The Dongar site says 21+. And this powers down as soon as the car is off and door is opened right? (That's my issue with using the 12 volt sockets, they stayed powered for too long). Hey. I replied to the YouTube comment as well but I have a 2020. I think this should work for 2019+ or even earlier. I'd be shocked if it didn't work for a 2019 since it's virtually the same car as side from that little plastic door on the dash. You need to have a auto dimming mirror And yes. This is on/off with the car. I needed that feature too since I only drive my car 1 or 2 days a week lol Quote Link to comment Share on other sites More sharing options...
enigma-2 Posted August 9, 2022 Report Share Posted August 9, 2022 This reminds me of a simular discussion on p&p connectors discussed back in the spring of 2021. It centered around how to remove the cowling surrounding the mirror and the two (or three) different connectors used because of different mirrors. If I remember there was a five pin (or may have been six pin) and sixteen or eighreen pin. (Tried to use the search function but couldn't find it). Quote Link to comment Share on other sites More sharing options...
awmustang Posted August 10, 2022 Report Share Posted August 10, 2022 On 8/8/2022 at 7:52 AM, Vanquished said: Hey. I replied to the YouTube comment as well but I have a 2020. I think this should work for 2019+ or even earlier. I'd be shocked if it didn't work for a 2019 since it's virtually the same car as side from that little plastic door on the dash. You need to have a auto dimming mirror And yes. This is on/off with the car. I needed that feature too since I only drive my car 1 or 2 days a week lol Thanks for that... I joined here so I could post my question but moderators have to approve posts of new members (smart policy). So I tossed it up on YouTube too. I did get the cover off so I could confirm the connector looked the same. I think it does, though I wasn't able to get it unplugged. It appears there is a clip to press down to release it but I wasn't able to unplug it. Any tips for disconnecting the connector? Quote Link to comment Share on other sites More sharing options...
awmustang Posted August 13, 2022 Report Share Posted August 13, 2022 On 8/9/2022 at 7:40 PM, awmustang said: Thanks for that... I joined here so I could post my question but moderators have to approve posts of new members (smart policy). So I tossed it up on YouTube too. I did get the cover off so I could confirm the connector looked the same. I think it does, though I wasn't able to get it unplugged. It appears there is a clip to press down to release it but I wasn't able to unplug it. Any tips for disconnecting the connector? Needlenose pliers was the answer. Quote Link to comment Share on other sites More sharing options...
Vanquished Posted August 16, 2022 Author Report Share Posted August 16, 2022 On 8/13/2022 at 5:34 PM, awmustang said: Needlenose pliers was the answer. Sorry about that, didn't see your post. It should be pretty easy to get off, on mine the wire assembly can be pulled out of the little cradle thing on the windshield so you can get a better hold of it. Glad you got it to work though Quote Link to comment Share on other sites More sharing options...
Vanquished Posted August 16, 2022 Author Report Share Posted August 16, 2022 On 8/9/2022 at 6:41 PM, enigma-2 said: This reminds me of a simular discussion on p&p connectors discussed back in the spring of 2021. It centered around how to remove the cowling surrounding the mirror and the two (or three) different connectors used because of different mirrors. If I remember there was a five pin (or may have been six pin) and sixteen or eighreen pin. (Tried to use the search function but couldn't find it). So I had asked this question in another thread I think. Before this adapter I had a wiretap and needed to find put which cables to connect it to. I made a decidedly worse video of that install (it's really hard to film and also do the install lol) I never really was able to make the wiretaps stick, I had to use electrical tape to hold them in place, the leads on the two taps I got were pretty thick though, it hink there is a company that makes wiretaps for dashcams (comes with those plugs and not usb) where the leads are like sewing pins so they go in securely, but I could be wrong Quote Link to comment Share on other sites More sharing options...
enigma-2 Posted August 17, 2022 Report Share Posted August 17, 2022 Mirror tap comes with several size pins to fit any mirror connector. During the installation, you choose the correct size (there's a chart on their website). You make have bought one of the Chinese knockoffs. To secure the harness, it also comes with a plastic wire tie. I found It's more than adequate to secure the harness, including having my radar detector's windshield mount fail; causing the detector to drop. Quote Link to comment Share on other sites More sharing options...
Vanquished Posted August 27, 2022 Author Report Share Posted August 27, 2022 On 8/17/2022 at 3:44 AM, enigma-2 said: Mirror tap comes with several size pins to fit any mirror connector. During the installation, you choose the correct size (there's a chart on their website). You make have bought one of the Chinese knockoffs. To secure the harness, it also comes with a plastic wire tie. I found It's more than adequate to secure the harness, including having my radar detector's windshield mount fail; causing the detector to drop. Naw. Mine didn't come with any sizes, I'm sure they were too big but that's the only option I had. I bought a USB one with a capacitor since I didn't use it for a radar detector so the janky phone jack connector wasn't what I needed. Either way the dongar is much easier lol. Quote Link to comment Share on other sites More sharing options...
THK Posted December 30, 2022 Report Share Posted December 30, 2022 I got one of these adaptors for my 22 Edge ST. Installation took 20 minutes. The only word of caution is be careful on how you remove the covers, otherwise this adapter is worth the money. Quote Link to comment Share on other sites More sharing options...
Polski Posted March 13, 2023 Report Share Posted March 13, 2023 I ordered one for my 2020. Saves so much time. Quote Link to comment Share on other sites More sharing options...
Dudester Posted April 10, 2023 Report Share Posted April 10, 2023 i just seen this and do not have the car in front of me, but the i pulled the Ford wiring diagram for a 2018 with auto dimming mirror and it is showing a 14 pin plug. Shows its coming on their site. 1 Quote Link to comment Share on other sites More sharing options...
Edge_u_Cational Posted April 27, 2023 Report Share Posted April 27, 2023 ordered, installed very easy..... then realized my dashcam is 12v not USB 1 Quote Link to comment Share on other sites More sharing options...
Sarahplainandtall Posted September 3 Report Share Posted September 3 (edited) I have a 2024 Edge ST line. The black box that holds the mirror onto the front windshield is huge and obstructs the view of a dash cam…where did y’all put your cameras so it’s not in your way but still gets enough view? And what dash cam do you have? Edited September 3 by Sarahplainandtall Quote Link to comment Share on other sites More sharing options...
IsraelT Posted 7 hours ago Report Share Posted 7 hours ago On 7/23/2022 at 4:13 PM, Vanquished said: Hey folks. Just thought I'd give you a heads up. Dongar Technologies finally made a 5-PIN adapter for our Ford Edges. This allows you to quickly and easily run a dashcam off your rearview mirror power without having to use a wiretap. I just did a full Install video of it here: Hope it helps! Hello, Thanks for the video. I have a 2020 Ford Edge ST Line and purchased the Dongar power adapter and found that I have 5 wires but the connector is a 6 pin connector with one not being utilized. its empty. This came from the factory like this. I thought it might be because of the rain sensor but I have only found 3 wire adapters when you have rain sensors. Any ideas? Thanks! Quote Link to comment Share on other sites More sharing options...
dabangsta Posted 1 hour ago Report Share Posted 1 hour ago I wasn't willing to pay $40+ for this, so I found the connectors and made my own for much less, without messing with the wiring in my vehicle (old me would have used t-taps). Dongar shows 2021+ and SEL or higher (with auto dimming mirror, but all models have it starting in 2019). So this connector under (well, over) the plastic cover in front of the rear view mirror is 6 pins on yours? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.