Corey 911 Posted August 31, 2021 Report Share Posted August 31, 2021 Replacing turbo on my Edge 120k miles. Does anyone know torque for oil feed tube bolts from engine to turbo. Thanks Quote Link to comment Share on other sites More sharing options...
WWWPerfA_ZN0W Posted August 31, 2021 Report Share Posted August 31, 2021 (edited) NOTE: Make sure that 2 new linked washers are installed. NOTE: Both water outlet tube clamps must be installed between the 2 paint stripes on hoses. Tighten to 28 Nm (21 lb-ft). NOTE: Make sure that 4 new turbocharger oil supply pipe gaskets are installed. Tighten to 25 Nm (18 lb-ft). NOTE: Make sure that a new turbocharger oil drain tube is installed. By not doing so, the turbocharger oil drain tube may leak and cause engine damage. Tighten to 10 Nm (89 lb-in). NOTE: Make sure that 4 new turbocharger-to-cylinder head studs, 4 new turbocharger nuts and a new turbocharger gasket are installed. Tighten to 50 Nm (37 lb-ft) in the sequence shown. Edited August 31, 2021 by WWWPerfA_ZN0W 1 Quote Link to comment Share on other sites More sharing options...
Big C Posted September 14 Report Share Posted September 14 I can’t find the sequence that you referenced? I am guessing I need to torque the studs first to the 37ft/lbs, then the gasket, turbo, then nuts. When torquing the nuts do I make an X pattern? Also, will I need to stage the torques like 20 ft/lbs, 30ft/lbs, then final 37ft/lbs? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.