steamroll9 Posted October 7, 2019 Report Share Posted October 7, 2019 Just got my 2019 Titanium a couple of weeks ago. Noticed that they reverse lights are a bit weak. Had an Escape previously, that had much brighter reverse lights(guessing cause they weren't LED). I know upgrading the lights is out of th e question with new LED design. Came across this https://www.vleds.com/shop-products/lp-series.html Anyone have any experience with accessing the wiring and whatnot in the hatch? Could easily run wire behind backup cam, but am clueless as to how to access anything in the hatch. Have used multiple VLED products in the past and have been very happy. Pricey, but you get what you pay for. Actually used their puddle lights for my Edge and they are great. Quote Link to comment Share on other sites More sharing options...
Gadgetjq Posted October 8, 2019 Report Share Posted October 8, 2019 Access to hatch wiring is fairly simple. Remove the pull handle on the passenger side of the panel and the screw(s) underneath. After those screws are out just start popping the panels off with a plastic tool or padded screwdriver. Once you get a panel started you can get your fingers under it and just move around the edges popping clips. You 'might' be able to access the reverse light harness with only one panel removed. If not then pull the next one. If you work better with pictures than descriptions download the factory service manual from MacT garage. Here's a link: https://drive.google.com/drive/folders/1Kv_Hsy6bOToW-NiO3ME9mY5TRvoHYKlS 2 Quote Link to comment Share on other sites More sharing options...
Al2 Posted November 12, 2021 Report Share Posted November 12, 2021 To steamroll9. Have the same Edge as you and the same poor back up lights and was looking at the Vleds . There doesn't appear to be much room to mount the light at the top of the plate. Did you install a Vleds and if so , how well does it work? Thanks Al Quote Link to comment Share on other sites More sharing options...
Xtra Posted November 13, 2021 Report Share Posted November 13, 2021 Are these are sealed units, and if the bulb burns out you have to replace the entire assembly lens, bulb, and all ? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.