Dg670 Posted April 10, 2017 Report Share Posted April 10, 2017 I need to replace my rear driveshaft on my 2008 edge AWD and noticed the 2009-2015 model only has one bearing mount and used ones are much cheaper than the used2007- 2008 shafts, does anyone no if the newer shaft with one bearing mount will bolt up to the 2008 without any issues. Quote Link to comment Share on other sites More sharing options...
omar302 Posted April 10, 2017 Report Share Posted April 10, 2017 As per this post it is a is a simple bolt-in. 1 Quote Link to comment Share on other sites More sharing options...
Josh6613 Posted May 8, 2017 Report Share Posted May 8, 2017 I need to replace my rear driveshaft on my 2008 edge AWD and noticed the 2009-2015 model only has one bearing mount and used ones are much cheaper than the used2007- 2008 shafts, does anyone no if the newer shaft with one bearing mount will bolt up to the 2008 without any issues.[/quot Did you happen to try this? And was it just a bolt in job? Quote Link to comment Share on other sites More sharing options...
WWWPerfA_ZN0W Posted May 9, 2017 Report Share Posted May 9, 2017 Should bolt right up. At least a couple of others have done this already. Quote Link to comment Share on other sites More sharing options...
Josh6613 Posted May 10, 2017 Report Share Posted May 10, 2017 Would it matter what year drive shaft I buy as long as it is a 2009 and up? Quote Link to comment Share on other sites More sharing options...
awh4992 Posted June 17, 2017 Report Share Posted June 17, 2017 (edited) Here's confirmation that the 2 piece propellor shaft/drive shaft bolts right into place on vehicles with the 3-piece driveshaft. This is the part number of the new one I ordered (hard to find at the moment): DT4Z-4R602-A. Apparently it's used on 2009-2013 AWD Edges. I used the 2 piece driveshaft on my 2007 Edge SEL+ AWD Shown below in this pic are the two driveshafts side by side. Edited June 17, 2017 by awh4992 2 1 Quote Link to comment Share on other sites More sharing options...
WWWPerfA_ZN0W Posted June 18, 2017 Report Share Posted June 18, 2017 Any difference in weight/distribution? Here's confirmation that the 2 piece propellor shaft/drive shaft bolts right into place on vehicles with the 3-piece driveshaft. This is the part number of the new one I ordered (hard to find at the moment): DT4Z-4R602-A. Apparently it's used on 2009-2013 AWD Edges. I used the 2 piece driveshaft on my 2007 Edge SEL+ AWD Shown below in this pic are the two driveshafts side by side. driveshaft.jpg Quote Link to comment Share on other sites More sharing options...
Bucknewby Posted June 18, 2017 Report Share Posted June 18, 2017 that's pretty slick Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.