Kimculley Posted March 14, 2016 Report Share Posted March 14, 2016 My back up system is not beeping. All sensors are working. When I put car in reverse the dashboard shows PA---. Have replaced fuse. What else could be wrong? Quote Link to comment Share on other sites More sharing options...
WWWPerfA_ZN0W Posted March 14, 2016 Report Share Posted March 14, 2016 How do you know the sensors are working, have you scanned them with a tool of some sort? Any incidents/issues involving the rear bumper? If everything else checks out, you may need to replace the Parking Aid Module (PAM). Probably requires a trip to the dealer for configuration. Or ask Circuit Medics if they repair, and if the cost is worth it. Removal and Installation NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed. Upload the PAM configuration to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Section 418-01 .Remove the LH rear quarter trim panel. For additional information, refer to Section 501-05 .Remove the 2 nuts and the PAM . Disconnect the electrical connector. To install, reverse the removal procedure. Download the configuration information to the PAM . For additional information, refer to Section 418-01 to carry out PMI . Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.