Dannyboy263 Posted November 8, 2015 Report Share Posted November 8, 2015 (edited) Dont have this issue anymore... too long ago Edited November 5, 2016 by Dannyboy263 Quote Link to comment Share on other sites More sharing options...
badgb21 Posted November 8, 2015 Report Share Posted November 8, 2015 Hi Quite a few have suffered with this. Answers are varied and buried in threads - my tale:- I installed 35w with a harness, ok for a short while then one light would not fire. Switch to off then 'on' and was ok. I tried capacitors and same story, ok for a few days, then same problem. Finally sorted by fitting Drive bright HIDs - Their ballasts have been designed to prevent this and they work! You could try swapping to their ballasts, though I'm sure they'll give you a million reasons why its better to buy their whole kit (which I did, it's good quality too!) See my post 103 here: http://www.fordedgeforum.com/topic/12054-what-is-the-best-hid-kit-for-the-edge/page-6 company is http://drivebright.com/home/ I have no association with them, but found them very knowledgeable, helpful and speedy. Good luck. Kev Quote Link to comment Share on other sites More sharing options...
Dannyboy263 Posted November 10, 2015 Author Report Share Posted November 10, 2015 Hi Quite a few have suffered with this. Answers are varied and buried in threads - my tale:- I installed 35w with a harness, ok for a short while then one light would not fire. Switch to off then 'on' and was ok. I tried capacitors and same story, ok for a few days, then same problem. Finally sorted by fitting Drive bright HIDs - Their ballasts have been designed to prevent this and they work! You could try swapping to their ballasts, though I'm sure they'll give you a million reasons why its better to buy their whole kit (which I did, it's good quality too!) See my post 103 here: http://www.fordedgeforum.com/topic/12054-what-is-the-best-hid-kit-for-the-edge/page-6 company is http://drivebright.com/home/ I have no association with them, but found them very knowledgeable, helpful and speedy. Good luck. Kev Thanks for your input and reply I did buy a couple things from them. Quote Link to comment Share on other sites More sharing options...
candurin Posted November 12, 2015 Report Share Posted November 12, 2015 Which kit are you using? If you read through some of the older posts, you'll find that the lower cost ballasts are prone to firing issues. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.