dagall Posted January 16, 2014 Report Share Posted January 16, 2014 Anybody have what the four bolts should be torque to. Replacing them right now. thanks Quote Link to comment Share on other sites More sharing options...
dagall Posted January 16, 2014 Author Report Share Posted January 16, 2014 I torqued them to between 55 and 60 ft-lbs. Hope that is enough. They didn't seem to overly tight when I loosened them. Quote Link to comment Share on other sites More sharing options...
WWWPerfA_ZN0W Posted January 16, 2014 Report Share Posted January 16, 2014 (edited) HTH. FWD AWD Installation All vehicles Install the wheel bearing and new wheel hub bolts. Tighten to 133 Nm (98 lb-ft). Position the brake caliper and anchor plate assembly and install the 2 bolts. To install, tighten to 55 Nm (41 lb-ft). Install the brake disc.AWD vehicles Using a suitable installation tool, install the halfshaft into the wheel bearing and wheel hub.Install the halfshaft hub nut. Tighten to 275 Nm (203 lb-ft). And a reference for hub/bearing replacement: http://www.fordedgeforum.com/topic/8329-07-sel-plus-awd-rear-bearinghub-replacement/ Edited September 4, 2016 by WWWPerfA_ZN0W Quote Link to comment Share on other sites More sharing options...
dagall Posted January 17, 2014 Author Report Share Posted January 17, 2014 Perfect, Thank You. I will retorque them today. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.