Trunk Light

were these all fairly easy to install?

Hi Bates 949,

The original bulb on the trunk is easy to replace. What I have done is to cut out a strip of aluminum tape and put it around the tapered ends of the LED light that I bought for this replacement. The available LED light out in the market has tapered ends, so in order to have it properly seated or installed on the terminals I have to use the aluminum tape to have a flat or level ends.

The passenger dome lights used the same type of bulbs on the trunk light, so the same technique was used. Just be careful in pulling out the diffuser.

The front dome or reading lights have the wedge type of bulbs, so the right size of LED lights should be used. The bulbs could be removed by pulling it out slowly with a rocking motion. Once again be careful in removing or pulling out the diffuser.

This is all I could share and I hope this could be beneficial to you, specially if you want to have the bragging rights of having a cool Edge.

Enjoy your mods and good luck!!!

Sirteman